Safety Certification
This CD player is made and tested to meet exacting safety standards. It meets
FCC
requirements and complies with safety performance standards of the U.S.
Department of
Health and Human Services.
CAUTION:
This CD player should not be adjusted or repaired by anyone except qualified
service personnel.
If servicing is required, contact an Authorized Mazda Dealer.
Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous laser exposure. Never operate the CD
player with the top case of the unit removed.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
NOTE:
For CD player section:
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two
conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any
interference received, including interference that may cause undesired
operation.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B
digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with
the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that
interference will not occur in a particular installation.
See also:
Seat Belt Extender
If your seat belt is not long enough, even
when fully extended, a seat belt extender
may be available to you at no charge from
your Authorized Mazda Dealer.
This extender will be only for you and ...
Sporty and Easy to Use
Like its predecessor, the Mazda CX-7 facelift makes it easy to enjoy its
powerful engines. The cockpit's ergonomic design is unusually sporty for an SUV.
The front seats offer good side support an ...
Lighter
The ignition switch must be in the ACC
or ON position
Press the lighter in and release it. When
ready for use, it automatically pops out.
CAUTION:
Don't touch the metal part of the
lighter, y ...


