Lighter

The ignition switch must be in the ACC


The ignition switch must be in the ACC or ON position
Press the lighter in and release it. When ready for use, it automatically pops out.

CAUTION:
lighter, you may burn yourself. Don't touch the metal part of the
lighter, you may burn yourself.

will overheat. Don't hold the lighter in because it
will overheat.

plug-in accessories such as Don't use the lighter socket for
plug-in accessories such as shavers and coffee pots. They may damage it or cause electrical failure. Use only a genuine Mazda lighter or the equivalent.

within 30 seconds, remove it to If the lighter doesn't pop out
within 30 seconds, remove it to prevent overheating.

    See also:

    Tire Labeling
    Federal law requires tire manufacturers to place standardized information on the sidewall of all tires. This information identifies and describes the fundamental characteristics of the tire and ...

    Tiedown Hooks
    CAUTION. Don't use the tiedown hooks under the front and rear for towing. They are designed ONLY for tying down the vehicle when it's being transported. Using them for towing will damage the bum ...

    Beep Sounds
    Seat Belt Warning Beep If the driver's seat belt is not fastened when the ignition switch is turned to the ON position, a beep sound will be heard for about 6 seconds. If the driver's seat belt i ...