Tool Storage

Tools are stored in the locations illustrated in the diagram.

Glove box


Glove box

Jack


Jack

To remove the jack

1. Turn the knob and remove the cover.


1. Turn the knob and remove the cover.

2. Turn the wing bolt and jack screw


2. Turn the wing bolt and jack screw counterclockwise.

To secure the jack

1. Insert the wing bolt into the jack with


1. Insert the wing bolt into the jack with the jack screw pointing back and turn the wing bolt clockwise to temporarily tighten it.

2. Turn the jack screw in the direction shown in the figure.

3. Turn the wing bolt completely to secure the jack.

NOTE:
If the jack is not completely secured, it could rattle while driving. Make sure the jack screw is sufficiently tightened.

    See also:

    Distributor in Each Area
    CANADA Mazda Canada Inc. 55 Vogell Road, Richmond Hill, Ontario, L4B 3K5 Canada TEL: 1 (800) 263-4680 (in Canada) (905) 787-7000 (outside Canada) PUERTO RICO/U.S. Virgin Island Plaza Motors Cor ...

    How the Air BagsWork
    How the Front Air BagsWork When air bag crash sensors detect a frontal impact of greater than moderate force, an electrical current is sent to the inflators. Gases are produced to inflate the fro ...

    Brake/Clutch Fluid
    Inspecting Brake/Clutch Fluid Level The brakes and clutch draw fluid from the same reservoir. Inspect the fluid level in the reservoir regularly. It should be kept at MAX. The level normally drop ...