Safety Certification
FCC ID: CB2MBLUEC07 IC:279BMBLUEC07
This device complies with Part 15 of the
FCC Rules and with RSS-210 of Industry
Canada. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
(2) This device must accept any
interference received, including
interference that may cause undesired
operation.
WARNING:
Changes or modifications not
expressively approved by the party
responsible for compliance could void
the user's authority to operate the
equipment.
The term “IC: ” before the radio certification number only signifies that Industry Canada technical specifications were met.
The antenna used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provided with installation instructions and transmitter operating conditions for satisfying RF exposure compliance.
See also:
Tire Labeling
Federal law requires tire manufacturers to place standardized information on
the sidewall of
all tires. This information identifies and describes the fundamental
characteristics of the tire
and ...
Exterior
The outside of the Tribute didn't get as much of a face-lift as did the
Escape. The grille lost its crossbar, and the Mazda logo has moved up, while the
headlights and taillights are new. Fog ligh ...
Rear WindowWiper and Washer
The ignition switch must be in the ON
position.
Rear WindowWiper
Turn the wiper on by turning the rear
wiper/washer switch.
ON - Normal.
INT - Intermittent.
Rear WindowWasher
To spray wa ...