Windshield Wipers

Turn the wipers on by pulling the lever


Turn the wipers on by pulling the lever down.

INT ― Intermittent LO ― Low speed
HI ― High speed
For a single wiping cycle, push the lever up to MIST.

MIST ― Mist

Windshield Washer

Pull the lever toward you and hold it to


Pull the lever toward you and hold it to spray washer fluid.

NOTE:
With the wiper lever in the OFF or INT position, the wipers will operate continuously until the lever is released.

If the washer does not work, inspect the fluid level. If it's normal, consult an Authorized Mazda Dealer.

    See also:

    HomeLink Wireless Control System
    NOTE: HomeLink and HomeLink house are registered trademarks of Johnson Controls. The HomeLink system replaces up to 3 hand-held transmitters with a single builtin component in the auto-dimming ...

    Fuel Requirements
    Vehicles with catalytic converters or oxygen sensors must use ONLY UNLEADED FUEL, which will reduce exhaust emissions and keep spark plug fouling to a minimum. 2.3-liter turbocharger engine Your ...

    Seat Belt (Except Center-Rear Position)
    NOTE: When using the center-rear seat belt, refer to “Center-Rear Position Seat Belt”. Fastening the Seat Belt 1. Grasp the seat belt tongue. 2. Slowly pull out the lap/shoulder belt. 3. Ins ...