Safety Certification
This CD player is made and tested to meet exacting safety standards. It meets
FCC
requirements and complies with safety performance standards of the U.S.
Department of
Health and Human Services.
CAUTION:
This CD player should not be adjusted or repaired by anyone except qualified
service personnel.
If servicing is required, contact an Authorized Mazda Dealer.
Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous laser exposure. Never operate the CD
player with the top case of the unit removed.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
NOTE:
For CD player section:
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two
conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any
interference received, including interference that may cause undesired
operation.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B
digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with
the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that
interference will not occur in a particular installation.
See also:
Outside Canada
Government regulations in Canada require that automobiles meet specific
emission
regulations and safety regulations. Therefore, vehicles built for use in Canada
may differ
from those sold in oth ...
Trunk Lid
WARNING:
Never allow a person to ride in the
trunk:
Allowing a person to ride in the trunk
is dangerous. In addition, the person
in the trunk could be seriously
injured or killed during sudden
...
Seat Belt Warning Light/Beep
The seat belt warning light illuminates
and a beep sound will be heard if the
driver's seat belt is not fastened when the
ignition switch is turned to the ON
position.
Conditions of operation
...


