Starting a Flooded Engine
If the engine fails to start, it may be flooded (excessive fuel in the engine).
Follow this procedure: 1. If the engine does not start within five seconds on the first try, turn the key to the LOCK position, wait ten seconds and try again.
2. Depress the accelerator all the way and hold it there.
3. Turn the ignition switch to the START position and hold it there - for up to ten seconds. If the engine starts, release the key and accelerator immediately because the engine will suddenly rev up.
4. If the engine fails to start, crank it without depressing the accelerator - for up to ten seconds.
If the engine still does not start using the above procedure, have your vehicle inspected by an Authorized Mazda Dealer.
See also:
Mazda6 2010 review
Mazda redesigned its midsize sedan just last year, but the radical new
styling failed to bring in a legion of buyers. In fact, sales of the 6 slipped
after the redesign, which rarely happens. Perh ...
WindshieldWipers and Washer
The ignition switch must be in the ON
position.
WARNING:
Use only windshield washer fluid or
plain water in the reservoir:
Using radiator antifreeze as washer
fluid is dangerous. If sprayed on t ...
Power Steering Fluid
Inspecting Power Steering Fluid
Level
CAUTION:
To avoid damage to the power
steering pump, don't operate the
vehicle for long periods when the
power steering fluid level is low.
NOTE:
Use spec ...