Reporting Safety Defects (U.S.A.)

If you believe that your vehicle has a defect which could cause a crash or could
cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTSA) in addition to notifying Mazda Motor Corporation (Your Mazda Importer/Distributor).

If NHTSA receives similar complaints, it may open an investigation, and if it finds that a safety defect exists in a group of vehicles, it may order a recall and
remedy campaign. However, NHTSA cannot become involved in individual problems between you, your dealer, or Mazda Motor Corporation (Your Mazda Importer/Distributor).

To contact NHTSA, you may call the Vehicle Safety Hotline toll-free at 1-888- 327-4236 (TTY:1-800-424-9153) ; go to http://www.safercar.gov; or write to: Administrator, NHTSA, 1200 New Jersey Avenue, SE., Washington, DC, 20590. You can also obtain other information about motor vehicle safety from http://www.safercar.gov.

NOTE:
If you live in the U.S.A., all correspondence to Mazda Motor Corporation should be forwarded to:
Mazda North American Operations.

7755 Irvine Center Drive.

Irvine, California 92618-2922.

or.

P.O. Box 19734.

Irvine, CA 92623-9734.

Customer Assistance Center or toll free at 1 (800) 222-5500.

If you live outside of the U.S.A., please contact the nearest Mazda Distributor shown in
this booklet.

    See also:

    Spare Tire and Tool Storage
    Spare tire and tools are stored in the locations illustrated in the diagram. (Except Mexico) (Mexico) Jack To remove the jack 1. Remove the trunk board. 2. Turn the wing bolt and jack sc ...

    Front Seats (Manually Operated Seats)
    WARNING: Do not modify or replace the front seats: Modifying or replacing the front seats such as replacing the upholstery or loosening any bolts is dangerous. The front seats contain air bag c ...

    Safety Certification
    FCC ID: CB2MBLUEC07 IC:279BMBLUEC07 This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) This device m ...