Rear Ventilation System

* Some models.

The rear ventilation system only blows cool air through the rear vents while the front climate control system is on. It does not blow air when the front climate control is off. The rear vents blow either outside air or recirculated air, depending on the position in which the air intake selector switch is set.

Front climate control is given priority over the rear ventilation control.

Control Switches


Control Switches

Rear ventilation control switch
Rear ventilation control switch

To get air flowing through the rear vents, first operate the fan control dial or turn on the AUTO switch on the front climate control operation panel. Then, switch on the rear ventilation control switch on the front climate control panel, or switch on either the low or high rear vent button on the rear console.

Rear vent buttons
Rear vent buttons

The rear vent switches adjust the airflow volume flowing from the rear vent.

OFF - Fan off.

LO - Low speed.

HI - High speed.

NOTE.

Only cool or cold air (no heat) blows through the rear vents while the front climate control is on. Heat for the rear passengers comes from under the front seats when the front heater is on and set to floor mode.

When pressing the rear ventilation control switch on the front control panel (with climate control system on), the rear ventilation system operates at low speed only. To change to high speed, press the HI rear vent button.

    See also:

    Break-In Period
    No special break-in is necessary, but a few precautions in the first 1,000 km (600 miles) may add to the performance, economy, and life of your Mazda. - Do not race the engine. - Do not maintain ...

    Manual Transmission Operation
    Manual Transmission Shift Pattern The vehicle is equipped with either a 5- speed or 6-speed manual transmission. The shift pattern for each is shown above. Depress the clutch pedal all the way d ...

    Steps for Determining the Correct Load Limit:
    Steps for Determining Correct Load Limit: (1) Locate the statement “The combined weight of occupants and cargo should never exceed XXX kg or XXX lbs” on your vehicle's placard. (2) Determine the co ...