After Getting In

- Are all doors closed and locked?

- Is the seat adjusted properly?

- Are the inside and outside mirrors adjusted?

- Is everyone's seat belt fastened?

- Check all gauges.

- Check all warning lights when the ignition switch is turned to the ON position.

- Release the parking brake and make sure the brake warning light goes off.

Always be thoroughly familiar with your Mazda.

    See also:

    Hazard Warning Flasher
    The hazard warning lights should always be used when you stop on or near a roadway in an emergency. The hazard warning lights warn other drivers that your vehicle is a traffic hazard and that t ...

    Brake/Clutch Fluid
    Inspecting Brake/Clutch Fluid Level The brakes and clutch draw fluid from the same reservoir. Inspect the fluid level in the reservoir regularly. It should be kept at MAX. The level normally drop ...

    Center-Rear Position Seat Belt (3-Point Type)
    Before using the center-rear lap/shoulder belt make sure tongue (A) and anchor buckle (B) are fastened. Fastening the Seat Belt 1. Grasp the tongue (C). 2. Slowly pull out the lap/shoulder be ...