After Getting In
l Are all doors closed and locked?
- Is the seat adjusted properly?
- Are the inside and outside mirrors adjusted?
- Is everyone's seat belt fastened?
- Check all gauges.
- Check all warning lights when the ignition switch is turned to the ON position.
- Release the parking brake and make sure the brake warning light goes off.
Always be thoroughly familiar with your Mazda.
See also:
Introduction
Be extremely careful and prevent injury to yourself and others or damage to
your vehicle
when using this manual for inspection and maintenance.
If you're unsure about any procedure it describes, w ...
Windshield Wipers
Turn the wipers on by pulling the lever
down.
INT ― Intermittent
LO ― Low speed
HI ― High speed
For a single wiping cycle, push the lever
up to MIST.
MIST ― Mist
Wind ...
Seats that fit better, provide greater support and are more functional
The raised sides on the front of the seat cushions were made 20mm larger than
on the first generation Mazda 3 to increase the leg support for a better fit.
The seat backs were also extended by 35m ...


