Head Restraints

* Some models.

Head restraints are intended to help protect you and the passengers from neck injury.

WARNING:
Always drive with the head restraints installed when seats are being used and make sure they are properly adjusted:
Driving with the head restraints adjusted too low or removed is dangerous. With no support behind your head, your neck could be seriously injured in a collision.

Height adjustment

To raise a head restraint, pull it up to the desired position.

To lower the head restraint, press the stopcatch release, then push the head restraint down.

Adjust the head restraint so that the top is even with the top of the passenger's ears, never the passenger's neck to prevent injury.

Front seat
Front seat

Rear seat
Rear seat

Removal/Installation

To remove the head restraint, pull it up while pressing the stop-catch.

To install the head restraint, press the uprights into the holes while pressing the stop-catch.

WARNING:
Always drive with the head restraints set up when seats are being used and make sure they are properly set up: Driving with the head restraints not set up is dangerous. With no support behind your head, your neck could be seriously injured in a collision.

    See also:

    Your Vehicle at a Glance
    Interior, exterior views and part identification of your Mazda. ...

    Hazardous Driving
    WARNING: Be extremely careful if it is necessary to downshift on slippery surfaces: Downshifting into lower gear while driving on slippery surfaces is dangerous. The sudden change in tire speed ...

    WindshieldWipers and Washer
    The ignition switch must be in the ON position. WARNING. Use only windshield washer fluid or plain water in the reservoir: Using radiator antifreeze as washer fluid is dangerous. If sprayed on t ...