Tool Storage
Tools are stored in the locations illustrated in the diagram.
Glove box
Jack
To remove the jack
1. Turn the knob and remove the cover.
2. Turn the wing bolt and jack screw counterclockwise.
To secure the jack
1. Insert the wing bolt into the jack with the jack screw pointing back and turn the wing bolt clockwise to temporarily tighten it.
2. Turn the jack screw in the direction shown in the figure.
3. Turn the wing bolt completely to secure the jack.
NOTE:
If the jack is not completely secured, it could
rattle while driving. Make sure the jack screw
is sufficiently tightened.
See also:
Exterior
The CX-9 manages to avoid the chunkiness of many SUVs, in part because of its
angular nose and car-like honeycomb grille. The SUV's beltline rises as it heads
rearward, and the sides are free of c ...
Highway Driving
On the highway is where you'll notice you're driving a small, light car, and
that's not always a great thing. Right off, there was fair amount of road noise,
and passengers noticed a lot of wind n ...
Cruise Control
With cruise control, you can set and
automatically maintain any speed of more
than about 32 km/h (20 mph).
WARNING:
Do not use the cruise control under the
following conditions:
Using the cruise ...