Starting the Engine
NOTE:
Engine-starting is controlled by the spark
ignition system.
This system meets all Canadian Interference- Causing Equipment Standard requirements regulating the impulse electrical field strength of radio noise.
1. Occupants should fasten their seat belts.
2. Make sure the parking brake is on.
3. Depress the brake pedal.
4. (Manual transmission).
Depress the clutch pedal all the way and shift into neutral.
Keep the clutch pedal depressed while cranking the engine.
(Automatic transmission).
Put the vehicle in park (P). If you must restart the engine while the vehicle is moving, shift into neutral (N).
NOTE:
(Manual transmission).
The starter will not operate unless the clutch is depressed sufficiently.
(Automatic transmission).
The starter will not operate if the shift lever is not in P or N.
5. Turn the ignition switch to the START position and hold (up to 10 seconds at a time) until the engine starts.
CAUTION:
Do not try the starter for more than
10 seconds at a time. If the engine
stalls or fails to start, wait 10 seconds
before trying again. Otherwise, you
may damage the starter and drain
the battery.
6. After starting the engine, let it idle for about 10 seconds.
NOTE:
- In extremely cold weather or after the
vehicle has not been driven in several days,
let the engine warm up without operating
the accelerator.
- Whether the engine is cold or warm, it should be started without use of the accelerator.
- If the engine does not start the first time, refer to Starting a Flooded Engine under Emergency Starting. If the engine still does not start, have your vehicle inspected by an Authorized Mazda Dealer.
See also:
Mazda 5 Facelift - An even Quieter Place to be
Mazda 5 facelift is not only more practical and easier to use, it is also a quieter
place to be, making its passenger cell even more communicative and relaxing. Engine
sound, for instance, has bee ...
Cargo
Larger dimensions also result in a larger trunk for the new Mazda6, which now
measures 16.6 cubic feet. That's up from the old car's 15.2 cubic feet, and it's
larger than key competitors like the ...
Beep Sounds
qSeat Belt Warning Beep
If the driver's seat belt is not fastened
when the ignition switch is turned to the
ON position, a beep sound will be heard
for about 6 seconds.
If the driver's seat belt ...